各位知道，思科那个UCS刀框装全宽刀片的时候，中间那个挡板怎么拆吗?

各位知道，思科那个UCS刀框装全宽刀片的时候，中间那个挡板怎么拆吗?
* n3 V7 q4 w- c7 i5 ~$ ~1 v
& q+ V9 w# i) k1 I$ F

Installing a Blade Server

Full-width Blade Servers are intended to run in the upper slots of the chassis, if the chassis will house both full-width and half-width servers. A chassis with four full width servers is fully supported.

' E1 x) u" c8 q# y7 I1 WProcedure

---

Step 1	If necessary, remove the slot divider (N20-CDIVV) from the chassis. Simultaneously pull up on the left side catch and push down on the right side catch as shown in callout 1 of the following figure. Pull the slot divider out of the chassis as shown in callout 2 of the following figure. Keep the slot divider in case it is needed at another time.Figure 5. Removing a Slot Divider / y. b) z9 V( u) m$ c Tip    To reinstall the slot divider, align it with the dimples in the slot top and bottom and slide it back in until it clicks into place.
Step 2	Grasp the front of the blade server and place your other hand under the blade to support it.Figure 6. Positioning a Blade Server in the Chassis + _. h8 b6 a* g( z   E. s: A: ^; K6 `6 {
Step 3	Open the ejector levers in the front of the blade server.
Step 4	Gently slide the blade into the opening until you cannot push it any farther.
Step 5	Press the ejector levers so that they catch the edge of the chassis and press the blade server all the way in.
Step 6	Tighten the captive screw on the front of the blade to no more than 3 in-lbs. Tightening with bare fingers only is unlikely to lead to stripped or damaged captive screws.

/ S2 S2 E: C# X, V9 khttp://www.cisco.com/c/en/us/td/ ... s/B420M3.html#ID450
4 G3 V' [% x7 N$ m- S# L

9 J) m( `7 e7 h# b' \( m